Q: Does Datavideo recommend specific aftermarket headsets for use with the ITC-100?
A: Most high quality headsets will work with the ITC-100; however, they usually have XLR connectors. We recommend using Datavideo CB-8M adapters to connect XLR headsets to the belt packs of the ITC-100. ITC-100 Product Manual go to Page 8
Q: What is the audio level on the 2 wire line of your ITC-100 base station – zero DBM or minus 15 dbm?
A: 1.67vP-P
Q: What is the line impedance?
A: 51kohm
hi
we have ITC-100 intercom and panasonic mixer AG-HMX100.
how can we connect ITC-100 to HMX100 in order to show active camera for cameraman?
Thanks
The ITC-100′s tally system was specifically designed to work with Datavideo Switchers. We do provide pin out specifications on the ITC-100 support page, which should provide the information needed to make your own custom cable. Since your switcher is a third party product, we cannot provide assistance with making the cable.
thank you for your help
I would be most appreciative if you couple please provide a ‘pin out’ of the tally light output on the belt pack (i.e. – what part of the 3 part plug relates to what light). Also if you could please let me know if the ITC unit/Belt Pack has current limiting on the signal that is sent to the LED’s.
Many Thanks.
Hi Craig,
Please click on the links below for ITC-100 pin assignment –
http://www.datavideo.us/support-downloads/itc-100/ITC100_tally_pin_cross_reference.pdf
http://www.datavideo.us/support-downloads/itc-100/XLR_cable_pin_assignment.pdf
Thanks!
Thanks for your response. However it is not the information I am after. What I need is the pin assignment of the jack between the ITC-100 BELT PACK and the tally light. I think this is simply a small stereo headphone jack lead.
Also does the ITC-100 have any limiting resistors that cut the voltage transfer to the tally light OR is it simply straight through such that the tally light receives the full voltage sent from the originating device.
Thanks
Craig